Para o eixo de engrenagem atualizado do MINI-Q

Tamanho:
– The shaft length with a wheelbase of 90mm, 94mm and 98mm is about 77.81mm,
– The shaft length with a wheelbase of 102mm is about 81mm,
– The shaft length with a wheelbase of 112mm is about 105mm.

Descriptions:
– Item name: shaft gear
– This product is a DIY product. It has also been violently tested personally. It is very durable and much more durable than previous wheelbase gears.

– The durability of the gear is not only the gear material, the installation steps and the gear gap must also be adjusted to play, otherwise no matter what material is there is the possibility of damage.

Installation steps and precautions:
– The front small teeth need to apply AB glue, and then use the pliers to clamp the middle shaft into the hole of the front small teeth, wait for the glue to dry after playing, at least two hours and the best setting effect , If it is disassembled, use a hair dryer to heat for one minute, the glue can be melted to remove the front pinion gear

– Please use AB glue to reinforce the rear small teeth of each tooth to prevent the gear from slipping, but the glue will leave marks on the appearance, but it does not affect the use. The glue is reinforced to make it more durable.

Note:the gears used in this intermediate shaft are all matched, so this shaft cannot be equipped with the original middle shaft teeth of the MINI-Q.

O pacote inclui:
1set x shaft gear