Specification for remote controller:
– 1.54inch colored screen display
– Silicone buttons,and clear button functions
– Built-in rechargeable battery 1500mah
– Type-C charging port
– Long term endurance of 18 hours
– Easy selection of 24 fishing points
– Distance, power, signal, direction, and status feedback display
– Weight for remote controller: about 103g

Specification for receiver board:
– Adapted battery: 6V,7.2V,7.4V,11.1V,12V lipo battery
(Do not use dry battery,as their poor current output capacity can cause the motor to fail to start)
– Adapted motor: 380 390 motor
– Max output current: 10A
– Motor interface: single way rated current 10A, peak current 20A
– LED light interface: directly connected to the LED light, the circuit board has already connected a 200 Ω resistor internally
– Communication method: bidirectional communication, power, distance, voltage, wireless signal, GPS signal, status information bidirectional transmission
– Control distance: 500meters
– Remote controller power consumption: 80mA
– Receiver power consumption: 130mA
– Weight for receiver board: about 55g

Remote control code matching operation:
The code between the remote control and the ship is already aligned at the factory, and users can use it directly.
Users may need to perform code checking operations in the following situations.
(1) Data loss caused by prolonged non electrification of the hull.
(2) Overloading of the ship’s electrical circuit caused the system to reset.
(3) The remote control is damaged and needs to be replaced.
(4) There is wireless co frequency interference or short remote control distance.

If the user needs to recheck the code in the above situations, please follow the following steps to che ck the code:
1. Long press “>” key twice to enter the code matching interface.
2. Short press “OK” to search for the next idle channel. After selecting the channel, the ship will be powered on again to complete the code matching, or short press the power key to exit the code matching.

Remark:
-The remote control is used in conjunction with the receiver board
– The wireless transmission signal is strong, and the distance between the remote control and the receiving board should be greater than 20cm when using it. Otherwise, if the distance is too close, it will reach saturation due to the strong wireless signal, and the remote control and receiving board cannot be connected
– The receiving board is tested well before send out
– The recommended battery is a 7.4V rechargeable battery, and the recommended motor is a 390 motor. It is not allowed to use a 775 large current motor. Two motors are the same specification, and the current cannot exceed 10A
– If a high-voltage high rate battery (such as 12V) is used and drives a high-speed and high-power motor (with a load current greater than 8A), it is easy to burn out the receiving board due to excessive power
– The receiving board is equipped with a built-in compass chip. Please install it according to the direction indicated on the back of the receiving board, so that the ship can automatically travel in a straight line.
– The unhook button in the remote control is not available, please ignore this function.

Package include:
1pcs x remote controller
1pcs x receiver